Throttle Trim - Carson Helldevil Notice D'emploi

Servo Reverse
These reverse switches
allow the rotation of the
servo(s) to be reversed.
The servo(s) rotate(s)
clockwise at NOR
position and rotate(s)
counterclockwise at
REV position.

Throttle trim

Move the trim tab to adjust the throttle
servo (or the speed
controller) at the
neutral position.
Charging Jack
Note: ON/OFF switch should
be at „OFF" position before charging!
ATTENTION!
Never attempt to
charge non
rechargeable
batteries!
Charging jack
8
Servo-Reverse
(steering)
Servo-Reverse
(throttle)
Steering trim
Rotate the trim to adjust the
steering servo at the neutral
position. When you adjust the
position of the steering servo,
set the steering rate adjuster
(ST.D/R) at the maximum
position so that the
movement of the
steering rate adjuster
is maximized and therefore
it is easy to adjust.
Steering rate adjuster (ST.D/R)
Strokes of the steering servo horn
can be adjusted by rotating this
steering rate adjuster (ST.D/R), in
the range from 10% to 100%.
The bigger the
percentage is, the more
sensitively the steering servo
operates.
How to change transmitter batteries
• To remove the battery cover,
push both of the tabs towards the
centre, and then pull the cover.
Please be careful that batteries
may pop out when the cover is
opened.
• If the transmitter
voltage indicator fails
to register, check the
contacts, especially
the negative (-)
terminals and
recheck that
batteries are fitted
correctly.
• Also make sure the
batteries are fully charged.
-
+