Technical Specifications; Water Tank; Coffee Grounds Container; A8 Coffee Bean Hopper - Philips 4300 Série Mode D'emploi

English
26
Problem
I cannot activate the

AquaClean water filter

and the machine asks
for descaling.
The new water filter
does not fit.
The machine is making a
loud noise.

Technical specifications

The manufacturer reserves the right to improve the technical specifications of the product. All the
preset quantities are approximate.
Description
Size (w x h x d)
Weight
Power cord length

Water tank

Coffee bean hopper capacity
Coffee grounds container capacity
LatteGo (milk container) capacity
Adjustable spout height
Nominal voltage - Power rating - Power supply
Cause
The filter has not been installed
or replaced in time after the
screen shows the AquaClean
reminder. This means your
machine is not anymore
completely limescale free.
You are trying to install another
filter than the Philips AquaClean
water filter.
The rubber ring on the
AquaClean water filter is not in
place.
It is normal that your machine
makes some noise during use.
The AquaClean water filter was
not prepared properly and air is
now drawn into the machine.
The water tank is not fully
inserted and air is drawn into
the machine.
Solution
Descale your machine first and then
install the AquaClean water filter.
Only the Philips AquaClean water filter
fits into the machine.
Place back the rubber ring on the
AquaClean water filter.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
Remove the AquaClean water filter from
the water tank and properly prepare it
for use before you place it back. See
chapter 'AquaClean water filter' for
step-by-step instructions.
Make sure the water tank is in the
correct position: remove it and insert it
again pushing it as far as possible.
Value
246 x 377 x 434 mm
7 - 7.5 kg
1200 mm
1.8 litres
275 g
12 pucks
250 ml
88-145 mm
See data label on inside of service door (Fig. A11)