Downdraft Vent Care; General Cleaning - Jenn-Air JID4436E Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT: Before cleaning, make sure all controls are
OFF and the cooktop is cool. Always follow label instructions
on cleaning products.
Soap, water, and a soft cloth or sponge are suggested first
unless otherwise noted.
Downdraft Vent
Do not use steel wool, abrasive powder cleansers, chlorine
bleach, rust remover, or ammonia because damage may occur.
Light to moderate soil
Can be cleaned with damp paper towels or sponge. Light
stains should be addressed with cleaner and cleaning pad.
Heavy soil, dark streaks, specks, and discoloration
Clean with affresh
Cooktop Cleaner or nonabrasive cleaner
®
and Cooktop Cleaning Pads.
Downdraft Vent Filter
The grease filter for the downdraft vent should be cleaned
regularly. Grease build-up decreases the downdraft vent's
performance.
To Clean Metal Vent Filter:
1. Open the vent filter door and remove the vent filter.
2. Clean the filter using warm water with a mild dishwashing
soap.
NOTE: The metal grease filter can be cleaned by handwashing
or in a dishwasher with a mild dishwashing soap at a low
temperature. Do not use aggressive or multi-phase cleaning
agents or clean at temperatures above 130°F (54°C)

DOWNDRAFT VENT CARE

General Cleaning

Drip Pan
If a spill occurs on the cooktop and into the downdraft vent area,
turn off the cooktop and downdraft vent as soon as possible. Let
the cooking surface cool, remove the downdraft filter, and clean
as necessary. Wipe the downdraft vent area clean. The drip pan
should always be removed, emptied, and cleaned anytime there
is a spill or boilover. The drip pan should be removed, emptied,
and cleaned often to avoid drip pan overfill and possible odors.
Drip pan removal:
A. Drip pan
B. Flat washers (2)
C. Screws (2)
1. Use a T20
®†
Torx
®
driver and remove the 2 screws and
washers from the tabs on the drip pan.
2. Remove the drip and dispose of the liquids and grease
buildup inside. Clean the drip pan inside and out with warm
soapy water, and then rinse and dry.
Drip Pan Installation:
NOTE: The drip pan should always be attached to the downdraft
vent except when it is removed for cleaning.
1. Replace the clean drip on the bottom of the downdraft vent
and install 2 screws and washers. Tighten the screws using
a T20
Torx
driver.
®
®
TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
®
5

Publicité

Table des Matières
loading

Table des Matières