Electrical Installation; After Installation - Zanussi ZKC38310 XK Mode D'emploi

Do not remove the mica cover on the ceiling of
the interior! This cover stops fat and pieces of
food damaging the microwave generator.
Warning! The front surface of the oven may be
wrapped with a protective film. Before using the
oven for the first time, carefully remove this
film, starting on the inside.
Make sure that the oven is not damaged in any
way. Check that the oven door closes correctly
and that the interior of the door and the front of
the oven opening are not damaged. If you find
any damage contact the Technical Assistance
Service.
DO NOT USE THE OVEN if the power cable or
the plug are damaged, if the oven does not
function correctly or if it has been damaged or
dropped. Contact the Technical Assistance
Service.
Put the oven on a flat and stable surface. The
oven must not be put close to any sources of
heat, radios or televisions.
During installation, make sure that the power
cable does not come into contact with any
moisture or objects with sharp edges behind
the oven. High temperatures can damage the
cable.
Warning: after the oven is installed you must
make sure you can access the plug.

After installation

The oven only functions when the door is
closed correctly.
After the first use, clean the inside of the oven
and the accessories, following the cleaning
instructions given in the section "Oven cleaning
and maintenance".
Fit the Turntable support in the centre of the
oven cavity and put the Turntable ring and the
Turntable plate on top, making sure they slot in.
Whenever you use the microwave, the turntable
plate and the respective accessories must be
inside and correctly fitted. The turntable plate
can rotate in both directions.
During installation, follow the instructions supplied separately.
18

Electrical Installation

Electrical installation must be performed by an
electrician qualified in accordance with the
legislation in force.
Before connecting the microwave oven to the
electric mains, check that the voltage and
frequency of the mains matches that which is
shown on the rating plate located in the cavity
front, and on the guarantee certificate, which
should be kept together with this manual.
The electric connection is made via plug (where
accessible) or via an omnipolar switch, which is
suitable for the intensity to be tolerated and
which has a minimum gap of 3mm between its
contacts, to ensure disconnection in case of
emergency or when cleaning the microwave.
The connection should include correct earthing,
in compliance with current norms. WARNING:
THE OVEN MUST BE EARTHED.
If the flexible supply cable fitted to the
microwave ever needs to be changed, it should
be replaced by an official After Sales Service,
because it requires special tools.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to people, animals or property if these
installation instructions are not observed.