Daikin FWECSA Manuel D'installation Et D'utilisation page 44

FWECSA
HEATING
MODULATING VENTILATION
As with step ventilation, the management logic for
modulating ventilation offers two possible operating modes:
• AUTOMATIC operation
• fixed-speed OPERATION
The operating percentage is selected by pressing the UP/
DOWN keys, while automatic ventilation comes on when
ventilation is set below the minimum (20%) or above the
maximum (100%) values.
MANUAL ventilation
AUTOMATIC ventilation
FORCED ventilation
AUTOMATIC OPERATION FOR 3- OR 4-SPEED UNITS AND
ON/OFF VALVE/S OR NOT INSTALLED:
COOLING
HEATING WITH 3-SPEED CONFIGURATIONS
FC66003946
Rev 00
Controller for units
USER MANUAL
It is strictly forbidden to reproduce this manual, even partially
HEATING WITH 4-SPEED CONFIGURATIONS
For configurations with 4 speeds, ventilation
for heating is delayed by 0.5°C to allow for an
initial natural convection phase.
WATER CONSENT
Regardless of what type of fan is installed (step or
modulating), ventilation depends on the system's water
temperature control. Depending on the work mode, we will
have different consent thresholds for heating and cooling.
COOLING
HEATING
Failure to have this consent, when the thermostat sends
a signal, will be displayed by the flashing symbol of the
mode that is currently in operation Cooling or Heating. This
enabling signal will be ignored if:
• the water probe is not required or it is in alarm conditions
because it is disconnected
• Cooling with 4-pipe configurations
EN
12