User Unit; Keyboard - Daikin FWECSA Manuel D'installation Et D'utilisation

USER UNIT

The main screen is divided into two parts (which are
referred to below as lt side and rt side) by a vertical line that
separates them.
the following information is contained on the lt side (from
top to bottom and lt to rt):
• room temperature (read by the remote probe on-board
the user unit, or by the probe connected to the I/O board
terminal board, according to the configuration)
• ambient humidity (if there is a humidity probe installed
and configured)
• status symbols:
time slots on
economy function on
dehumidification running
minimum room temperature function
enabled
valve/s open
electric heater enabled/on
SMALL network on RS485 on
serial communication
with supervision system
locked keyboard
EN
3
Controller for units
OPERATION MANUAL
It is strictly forbidden to reproduce this manual, even partially
• alarm signal: symbol and identification of the type of
alarm overwrite the area normally dedicated to status
symbols.
The following information is contained in the rt side (from
top to bottom)
• identification of the operating mode
COOLING mode
HEATING mode
• identification of the ventilation status
• identification of the room air temperature SET value
If the unit is OFF the side will be completely covered by the
word OFF written vertically across it.

KEYBOARD

There are 6 keys on the display screen; below are the basic
functions associated with each key.
ON/OFF KEY
• switch the unit on/off
• go back to main screen
PRG KEY
Prg
• access to the MENU
MODE KEY
• change operating mode (HEATING/
Mode
COOLING)
UP ARROW KEY
• change ventilation values/speed
• scroll through screens
SET KEY
• change SET/VENTILATION mode
Set
• confirm value/return in screen scroll mode
DOWN ARROW KEY
• change ventilation values/speed
• scroll through screens
FWECSA
FC66003946
Rev 00