Seko Pool Basic Pro Evo Manuel D'installation page 16

DISPLAY VIEW WITH THE SYSTEM ON STAND-BY
Stand-by display (Configuration A)
Alr
760mV
Stand-by display (Configuration B)
Alr
1
760mV
Alr
2
760mV
Alr
3
760mV
*If AdvancedFlow=On and during Flocculant dosing, the recirculation pump stops and
blocks the system dosing, when the pump restarts, the Flocculant will restart the cc dosing
calculated from the start.
SHORTCUTS
To access the shortcut menu press the SET key for at least 3 seconds when the system is in stand-by.
Display Set (Configuration A)
pH-= 7.2
pH+= 7.0
Display Set (Configuration B)
pH= 7.2
Floc= 1.0cc/m3
000013791
8.3pH
8.3pH
1200cc
8.3pH
FLOC 37m
8.3pH
Rx= 760
Rx= 760
Rev. 1.0
Operation
The display is divided into 4 parts:

On the upper left hand side the alarm is
shown, when present.

On the lower left hand side the value read by
the Rx probe is shown.

On the lower right hand side the value read
by the pH probe is shown
Operation
The display is divided into 4 parts:

On the upper left hand side the alarm is
shown, when present.

On the upper right hand side three views are
displayed:
The first is the stand-by system
o
The second shows the cc countdown
o
dosed by the pump
The third is the waiting time until the
o
next dosing with the message FLOC.

On the lower left hand side the value read by
the Rx probe is shown.

On the lower right hand side the value read
by the pH probe is shown
Operation
The pH- value flashes. It can be modified using the +
and – keys and confirmed using Enter. For the pH+
and Rx value, repeat the same procedure, press
Enter to confirm and exit.
Operation
The pH- value flashes. It can be modified using the +
and – keys and confirmed using Enter. For the
Redox and Flocculant value, repeat the same
procedure, press Enter to confirm and exit.
15