Adjustment Of The Manual Timer Program (P6) - SilverCrest SKWH 2000 A2 Instructions D'utilisation Et Consignes De Sécurité

Press the week-timer button 9 .
Then the timer program is shown on the display.
With each pressing the button 9 , you will switch
to the next program P1 - P2 - P3 - P4 - P5 - P6 - OFF
(see Program Table on the fold-out rear side).
Confirm your selection by pressing the OK
button 5 .
Depending on the program selected and de-
pending on the time (day and time), the week
timer indicator B will light up or flash on the
display panel.
If values A and B are lit continuously, the selected
program is active or the device turns off automatically.
If values A and B are flashing, the selected pro-
gram is not active. Then the device switches off after
30 seconds again. In the meantime, the fan runs un-
til the standby mode. Values A and B continue to
blink until the program automatically intervenes and
turns the device on.
7.9 Adjustment of the manual timer
Program (P6)
Turn on the device (see Starting Up).
Select the first or the second heating level. To do
so, press the heating level button
A lights up on the display. See Chapter "setting
of heating levels". Alternatively, you can select a
desired temperature (see chapter "Temperature-
Setting").
Please note: The wall-mounted ceramic fan heater
will be turned ON depending on the selected pro-
gram and run the last heating level or temperature
you selected.
Press the shown week-timer button 9 :
Then the timer program is shown on the display.
Press and hold the week timer button 9 until
„P6" appears in the display.
Confirm your selection by pressing the OK
button 5 .
Now the number of the respective day of the
week is flashing (see the table). By pressing the
plus 8 or minus button 7 , you can set the first
day of the week which the timer should be set for.
Confirm your selection by pressing the OK
button 5 .
The number of the start time hours appears on
the display. You can adjust it by pressing the
plus 8 or minus button 7 .
Please note: Please note that the start time must be
before the end time and that only hours (no minutes)
can be set. The start time and end time must relate
to the same day.
Confirm your selection by pressing the OK
. The symbol button 5 .
11
The number of the end time hours appears on
the display. You can adjust it by pressing the
plus 8 or minus button 7 .
After 5 seconds, you will automatically switch to
the next week.
Now you can set the start and end times for
each day of the week one after another.
Please note: If you want to disable the timer for
a day of the week, select start and end time „00".
Once you have set all 7 days of the week, the
week timer is active. Depending on the function,
the indicators A and B shine or blink.
If values A and B are lit continuously, the selected
program is active or the device turns off automatically.
01. Monday 02. Tuesday
03. Wednesday 04. Thursday
05. Friday 06. Saturday
07. Sunday
GB/IE/NI/CY/MT 21