Safety Measures - TECNOMAGNETE MaxX 125 Manuel D'emploi Et D'entretien

USE AND MAINTENANCE MANUAL
USE AND MAINTENANCE MANUAL
5

SAFETY MEASURES

5-A) DO NOT USE THE HOISTING DEVICE
to lift and transport people
5-B) DO NOT LIFT LOADS
while people are walking in the manoeuvring space
5-C) DO NOT WALK, STOP, OPERATE OR MANOEUVRE
beneath the lifted load
5-D) DO NOT LET UNTRAINED PERSONNEL
or children 16 or younger use the hoisting device
5-E) DO NOT USE THE HOISTING DEVICE
without proper working garnments or individual protection devices
5-F) DO NOT LEAVE
the lifted load unattended
5-G) DO NOT USE THE HOISTING DEVICE
for operations which differ from the prescribed ones
5-H) MAKE SURE THE LOAD DOES NOT SWAY
during transportation
5-I) DO NOT REACH THE AREA OF "END OF RUN"
at full speed when moving the load
5-L) DO NOT MAGNETIZE THE LIFTER
before setting it on the load
5-M) DO NOT HOIST LOAD
before locking the manual control lever in MAG position
5-N) DO NOT HOIST LOAD
weighing more that lifter capacity
5-O) DO NOT HOIST LOAD
with dimensions exceeding those shown on lifter nameplate or in manual (see per form ance
sheet)
5-P) DO NOT HOIST LOAD
if unbalanced
5-Q) DO NOT HANDLE LOAD
before making sure of perfect magnetic hooking. To verify it carry out a test by lifting the load
two or three inches (10cm)
5-R) DO NOT DEMAGNETIZE LIFTER
before fi rmly setting down entire load on the fl oor and making sure of perfect stead i ness of
load.
5-S) FOLLOW THE INSTRUCTIONS
given in the use and installation manuals
5-T) CHECK
the solidity of the supporting structure
5-U) MAKE SURE
the working space is free of obstacles before starting any operation
5-V) CHECK
maintenance conditions (cleanliness, lubrifi cation...)
5-W) ALWAYS USE
entire lifter pole surface
5-Z) ALWAYS KEEP
contact poles areas perfectly fl at and parallel
Page 35 of 146
®