Information Data; Fields Of Use; Limits Of Use; Improper Use - TECNOMAGNETE MaxX 125 Manuel D'emploi Et D'entretien

USE AND MAINTENANCE MANUAL
USE AND MAINTENANCE MANUAL
2.1

INFORMATION DATA

The manufacturer's identifi cation and CE RULING conformity plate is placed on the machine
of the equipment. It is also reported here below
WARNING
The plate must not be removed at any time even if the machine should be sold again. Always refer
to the serial number when contacting the manufacturer.
The company is not to be held responsible for damage to property or accidents to people which
might occur if the above mentioned warnings are not observed. In such a case, the operator is the
only person responsible.
2.2 FIELD OF USE
Machine shops, metallurgical and mechanical shops, iron metallurgical shops and in gen er al all
work locations requiring fast, reliable handling of ferrous loads by bridge or crane.
The lifter must be installed on a lifting installation in an environment with the necessary emergency
exits.
The working environment must comply with the following limits:
- minimum temperature
- maximum temperature +60°C
- maximum humidity 80%
2.3

LIMITS OF USE

The permanent magnet equipment is really a magnetic anchor system with a clip anchor hook. It can,
therefore, work as a lifter only if hung on a hook of the lifting and displacement machine. Limits of
use of the permanent magnet lifters are specifi ed on the identifi cation plate applied on the lifter and
in the Use and Maintenance Manual (see performance sheet).
2.4

IMPROPER USE

An improper use signal of the permanent magnet lifter concerns limits of use set for them (see per-
form ance sheet). Improper use means any procedure not set forth in the performance sheet or on
the nameplate of the lifter.
-10°C
®
Page 26 of 146