Beverage Center Care - Whirlpool WUB35X24HZ Guide D'utilisation Et D'entretien

To Stock the Beverage Center:
1. Place juices, sodas or other canned beverages on the
glass shelves.
Top Wine Rack:
1. Slide wine rack open.
2. Starting on the left-hand side of the wine rack, place the
first bottle with the neck of the bottle facing the front of
the Beverage Center.
3. Place the next bottle on the rack with the neck of the
bottle facing the back of the Beverage Center.
Alternate the direction of the bottles, in this manner, until
the rack is full.
4. Slide the wine rack into place.
Cleaning
Explosion Hazard
Use nonfl ammable cleaner.
Failure to do so can result in death, explosion, or fi re.
Clean the Beverage Center about once a month to avoid
buildup of odors. Wipe up spills immediately.
To clean your Beverage Center:
1. Unplug Beverage Center or disconnect power.
2. Remove all removable parts from inside, such as
shelves, etc.

BEVERAGE CENTER CARE

NOTE: The wine rack can be stocked with the bottles
facing either direction, however, to optimize storage
adjacent bottles should be facing in opposite directions.
Bottom Rack 6 Bottles
Bottom Wine Rack
Starting from left-hand side of the bottom rack, place the
first bottle with the neck of the bottle facing the front of the
Beverage Center. Continues to place the remaining bottles
facing in the same direction.
3. Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth
and a mild detergent in warm water.
• Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning
waxes, concentrated detergents, bleaches or cleansers
containing petroleum products on plastic parts, interior
and door liners or gaskets. Do not use paper towels,
scouring pads, or other harsh cleaning tools.
These can scratch or damage materials.
• To help remove odors, you can wash interior walls with
a mixture of warm water and baking soda (2 tbs to 1 qt
(26 g to 0.95 L) of water).
4. Wash stainless steel and painted metal exteriors with a
clean sponge or soft cloth and a mild detergent in warm
water. Do not use abrasive or harsh cleaners, or
cleaners containing chlorine. These can scratch or
damage materials. Dry thoroughly with a soft cloth.
5. Replace the removable parts.
9