Basic Functions - Hansgrohe RainBrain 15841 Série Mode D'emploi

Basic functions

Touch display with direct selection of the
basic functions
Control dial for adjusting the water temperature and
volume.
Turn left to lower the temperature
Turn right to raise the temperature
Pressing the control dial starts and stops the selected
showers.
Function LED red
States:
Unit off, LED off
Unit standby, LED on
Unit on, LED goes out
The Hansgrohe RainBrain shower system can be very easily operated
using its innovative touch display.
Every touch of a button is confirmed both audibly and visually by a red
edge around the pressed button.
On the colour display you can read all of the important information at
any time such as:
• Active showers
• Set water temperature
• Time
• Active music titles
• User
• Shower program
• Light
6
English:
Operating instructions
38,
Warm up
Volume
13:56
Power button turns unit on
and off.
On / off scenario
Off / cleaning mode:
Function LED is off, display and control dial are not lit, power button
sensitive (the unit can be activated by pressing it).
Standby:
Starts after 15 min if no user is switched on and nothing is being used. Function
LED is on, display and control dial are not lit. All buttons and and display are
sensitive: if they are pressed the red function LED goes out and the display
turns on. The unit stays in standby mode until it is actively switched off.
On:
Function LED is off, display and button are lit, all buttons and display ready.
°C
5
Menu
User key