Error Display; Daily System Restart; Cleaning - Hansgrohe RainBrain 15841 Série Mode D'emploi

Error display

Whenever an error occurs, an error message appears and all showers are
stopped.
Three types of error modes can occur:
1. No danger:
Errors that present no danger to the user or unit and affect only e.g. the
water volume. You can still shower if the selected functions are not affected
by this error.
The base image appears after acknowledgment. The system will be avail-
able again.
. Emergency mode: (ill. 3):
Even though an error has occurred, you can continue to shower in
emergency mode. An emergency mode message appears. Only the hand
shower can be selected. If no hand shower is configured, the system goes
into Endangerment mode.
. Endangerment: (ill. 1 and 2)
Errors that lead to endangerment of the user due to scalding, or possible
damage to the RainBrain cause the system to shut down. Go to the error
list at the system level, note the uppermost error and report it to Hansgrohe
Service.
Warning
1
CAUTION
An error has occurred! The
system has been stopped.

Operating instructions
Next
English:
Warning

00800000 04 2008.10.24 - 07:42:39
00800000 02 2008.10.24 - 07:12:54
Acknowledge error?

Emergency operation
38,
Warm up
9.
Volume
13:56

Daily system restart

The Hansgrohe RainBrain system automatically restarts daily at 12 o'clock
in the afternoon. During this restart the positions of the motors are checked
and the touch panel is restarted.
In order for the restart to occur, the touch panel must be in standby mode.
If this is not the case, the restart is postponed by a half hour until the restart
can take place.

Cleaning:

To clean the touch panel press the power button for 3 seconds. The touch
display switches off and does not respond to touch. To switch it back on
again, press the power button for another 3 seconds.
Yes
°C
°F
5
0
Menu