Husqvarna T525 Manuel D'utilisation page 30

Kickback and guide bar nose radius
Guide bar
Length, in/cm Pitch, in
10/25 1/4
12/30 1/4
10/25 3/8
12/30 3/8
10/25 3/8
12/30 3/8
The usable cutting length is usually 1 in less than the
nominal guide bar length.
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain. A
Husqvarna file gauge makes sure that you get the
H00 5/32 in / 4.0 mm
H37 5/32 in / 4.0 mm
S93G 5/32 in / 4.0 mm
30
Gauge, Max. nose ra-
in/mm dius
0.050/1.3 R10
0.050/1.3 R10
0.050/1.3 7T
0.050/1.3 7T
0.050/1.3 7T
0.050/1.3 9T
580 68 74-01
505 24 37-01
587 80 90-01
Saw chain
Type
Husqvarna
H00
Husqvarna
H37
Husqvarna
S93G
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
0.025 in / 0.65
mm
0.025 in / 0.65
mm
0.025 in / 0.65
mm
Length, drive Low kickback
links (no.)
60
68
40 Yes
45
40 Yes
45
30° 85°
30° 80°
30° 60°
732 - 015 - 11.12.2018