Technical Data; Description Of Product Parts - Rexel Home Manuel D'utilisation

Technical data

Cutting Type
Shred Size
Sheet Capacity (one pass)
Entry Width
Product Dimensions
Rated Voltage/Frequency
Rated Current
Please read this instruction leaflet carefully before use.
Introduction
Thank you for choosing this Shredder from Rexel. We are sure
it will serve you well, but please take a little time to read these
instructions to ensure you get the best out of your machine.
Safety First
• Please store this instruction manual in a safe place for future
reference.
• Please pay close attention to the safety symbols on the top of
the shredder and operate the machine accordingly.
• If the shredder needs cleaning, unplug the unit from the
power socket and use a damp cloth. NB. Do not use any
cleaning products to clean the unit.
• Do not position the unit near to an object that radiates heat.
• Do not place the unit in a damp environment.
• Take care not to splash any liquid onto the machine.
• Return the product and proof of purchase with receipt to the
store at which it was purchased if...
- The power cable or plug is broken.
- The machine malfunctions because liquid was accidentally
spilt onto the machine.
- The shredder doesn't operate despite following the
guidelines in the manual.
• Make sure the power cable isn't a trip hazard.
• Please ensure the power supply is compatible with the
requirements of the machine (220-240V 50Hz).
• To avoid risk of injury, don't open the machine's casing to
attempt DIY repair. Any attempted repair by an unqualified
person will invalidate the warranty.

Home/ Alpha
Confetti Cut Ribbon Cut
4mm x 30mm 7.25mm
5 5
223mm 220mm
323 x 155 x 365mm 285 x 142 x 344mm
220-240V~50Hz 220-240V~50Hz
0.8A 0.8A
m
Description of
product parts
1 Power Cable
2 Paper entry slot
Preparation before use
How to use the shredder correctly:
• Take care not to insert fingers, ties or other objects into the
entry slot of the shredder.
• Try to avoid paper clips, staples, laminating materials, plastic
bags etc. from being passed through the shredder. This will
prevent damage to the cutters.
• Do not shred wet paper as it can tangle in the cutters.
• Do not shred more than the stated sheet capacity in one
pass.
• Do not shred continuously for more than 3 minutes at a time.
Running the unit for too long may make the motor overheat.
If the motor over heats, allow it to cool down for at least 30
minutes before resuming use.
• Do not use the "REV" (reverse) function if it's not necessary.
Over use of the "REV" function can result in shredded paper
becoming jammed in the entry slot, which will adversely
affect the performance of the shredder.
Warranty
The product is guaranteed for 24 months from the date
of purchase – please return the unit to your retailer if you
experience any problems. This does not affect your statutory
rights.
Correct operating procedure
Insert plug into the AC power socket.
1
Push the switch to the ON/AUTO position (standby mode).
2
When not in use, push the switch to the 0 (off position).
3
4 Empty the waste basket regularly to ensure the shredder
exit does not become blocked with paper.
( fig 1 )