Reversing Door - Electrolux EIED200QS Instructions D'installation

12

Reversing Door

1 Protect flat work surface, such as top of dryer or floor
near dryer, with a soft cloth or towel.
2 Open dryer door and remove the two hinge screws.
Remove lower screw first, then upper screw.
3 Gently place dryer door face down on flat, covered work
surface.
4 Locate the 12 screws (no. 1-12) on the inner door ring.
Remove and save these 12 screws.
5 Separate inner door ring from the rest of the door.
6 Release the door switch striker and move it to the
opposite location and reinstall. Set the inner door ring
aside.
2
1
7 Lift the inner lens and set it aside.
8 If your model has 8 screws securing the outer lens in
place, remove and save them for later. Lift and rotate
the outer lens 180°. Lower the outer lens back in place.
180
9 Reinstall the 8 screws if removed in previous step. If no
screws were present, move to next step.
3