Maintenance Free Battery; Motor Housing - BEAL NPMS12 .5/96 Notice D'emploi

How To Check And Adjust The Drive Brake (Figure 12)
Completely push the clutch/brake pedal forward. Set the
parking brake. Move the shift lever to the neutral (N)
position. Push the unit. If the rear wheels rotate, adjust
or replace the brake pads. Adjust the drive brake (A) as
follows.
1. The location of the drive brake (A) is on the right side
of the gearbox (C).
2. Make sure the parking brake is set and the shift lever
is in neutral (N). Turn the hex nut (B) in a clockwise
direction until the rear wheels do not turn when the unit
is pushed forward.
3. Release the parking brake and push the unit. If the
unit does not roll, turn the hex nut (B) in a counter-
clockwise direction until the unit rolls.
4. Set the parking brake. Push the unit. If the rear wheels
do not turn, the drive brake (A) is correctly adjusted.
Release the parking brake.
WARNING: If you cannot correctly adjust the drive
brake, replace the brake pads. Correct replacement
parts and assistance are available from an
authorized service centre.

Maintenance Free Battery

How To Remove The Battery (Figure 4)
To charge or clean the battery (A), remove the battery (A)
from the unit as follows.
WARNING: To prevent sparks, dis connect the black
battery cable (H) from the negative (-) terminal
be fore you disconnect the red cable (E).
WARNING: The battery contains sulphuric acid
which is harmful to the skin, eyes and clothing. If
the acid gets on the body or clothing, wash with
water.
1. Disconnect the black cable (H) from the negative (-)
terminal.
2. Disconnect the red cable (E) from the posi tive (+)
terminal (D).
3. Lift the battery tray (C) and the battery (A) out of the
unit.
20
How To Charge The Battery (Figure 4)
WARNING: When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an
explosion.
1. Before you charge the battery (A), remove the
battery (A).
2. To charge the battery (A), use a 12 volt bat tery charger.
Charge at a rate of 6 amperes for 1 hour.
3. Install the battery (A).
WARNING: To prevent sparks, fasten the red cable
to the positive (+) terminal before you connect the
black cable.
4. Fasten the red cable (E) to the positive (+) terminal
(D) with the fasteners as shown.
5. Fasten the black cable (H) to the negative (-) terminal
with the fasteners as shown.

Motor Housing

How To Level The Mower Housing (Figure 13 and
Figure 14)
If the mower housing is level, the blade will cut easier and
the lawn will look better.
WARNING: Before you make an in spection,
adjustment, or repair to the unit, disconnect the
wire to the spark plug. Remove the spark plug wire
to prevent the engine from starting by accident.
1. Make sure the unit is on a hard flat surface.
2. Check the air pressure in the tyres. If the air pressure
is incorrect, the mower housing will not cut level. Make
sure the tyres are inflated to: Front Tyres 0,97 BAR
(14 PSI), Rear Tyres 0,69 BAR (10 PSI).
3. (Figure 13) Move the lift lever (A) to the lowest cut
position (B).
WARNING: The lifter lever (C) is spring loaded.
Make sure the lift lever (C) is locked in the lowest
cut position (B).
www.yvanbeal.fr