Lubrication; Disassembly - BEAL NPMS12 .5/96 Notice D'emploi

4. (Figure 14) Loosen the left and right
(A). Push down on each side of the mower housing.
Make sure both sides of the mower housing are setting
on a flat sur face. Also, make sure the lift links are loose
and can easily move up or down.
5. Push down on the lift links (B) and tighten the left and
right adjuster knobs (A). Make sure the adjuster knobs
(A) are tight. If necessary, use a wrench to tighten the
adjuster knobs (A).
6. (Figure 13) Raise the lift lever (A).
7. Mow for a short distance. If the height of cut is not
level, repeat the above steps.

Lubrication

Where To Lubricate (Figure 15)
Models with grease fittings: Lubricate with
grease gun.
Apply grease with a brush to the areas shown.
Lubricate the areas shown with engine oil.
NOTE: Apply grease to the steering gear as sembly.
CAUTION: If the unit is operated in dry areas that have
sand, use a dry graphite spray to lubricate the unit.
Check The Tyres
Check the air pressure in the tyres. Tyres with too much air
pressure will cause the unit to ride rough. Also, the wrong
air pressure will keep the mower housing from cutting level.
The correct air pressure is: Front Tyres 0,97 BAR (14 PSI),
Rear Tyres 0,69 BAR (10 PSI).
ad juster knobs

Disassembly

How To Replace The Motion Drive Belt
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Remove the mower housing. See the instruc tions on
"How To Remove The Mower Hous ing".
Completely push the pedal forward and en gage the
parking brake.
(Figure 16) Remove the idler pulley (A).
(Figure 17) To access the belt guides (A), remove the
battery and battery tray. See "How To Remove The
Battery".
Loosen the belt guides (A) at the drive pulley (B).
(Figure 16) Remove the motion drive belt (B) from the
drive pulley (C).
(Figure 18) Remove the adjuster nut (B) from the
shifter bracket (C). Pull the motion drive belt over the
shifter bracket (C).
(Figure 19) To remove the motion drive belt (A) from
the stack pulley (B), pull the front end of the belt under
the stack pulley (B) and then back between the stack
pulley and the steering plate (C).
(Figure 20) Remove the access panel (A).
Remove the two screws (D) that attach the steering
shaft assembly (B). Raise the steering wheel and
steering shaft assembly (B). Pull the motion drive belt
(C) under the steering shaft assembly (B).
Remove the motion drive belt. A correct re placement
part or assistance is available from an Authorized
Service Centre in your area.
To install the motion drive belt, reverse the above
steps.
(Figure 21) Check the routing of the
belt (A). Make sure the motion drive belt is installed
correctly on the idler pulley (B). Make sure the
steering shaft assembly (C) is inside the motion drive
belt (A).
motion drive
21