Rona RFS-15-1/2G-001 Guide D'utilisation page 11

IMPORTANT SAFETY INSTRUCTIONS
20. DO NOT DRIVE STAPLES on top of other fasteners, or with the tool at too
21. FIRE FASTENERS INTO WORK SURFACE ONLY. Do not drive staples
22. DO NOT DRIVE STAPLES too close to the edge of the workpiece. The
23. STAY ALERT. Keep hands and body away from the path of any potential
24. PREVENT ELECTRIC SHOCKS. Prevent body contact with
25. KEEP WORK AREA CLEAR of obstructions.
26. STORE IDLE EQUIPMENT. When the tool is not being used, it should be
27. EMPLOYERS must enforce compliance with the safety warnings and all
WARNING: The warnings, cautions, and instructions detailed in this manual
!
UNPACKING
Check immediately that all parts and accessories are included. If anything is
missing or broken, contact your retailer or call 1.888.267.7713.
 Hammer
 Stapler
 Air plug
 S3 Hex key
 S4 Hex key
 S5 Hex key
 Air tool oil
 Manual
SPECIFICATIONS
 Shoots standard 15-1/2 ga. 1/2" crown flooring staples minimum 3/4"
 Operating pressure: 70-90 PSI / 488 to 621 kPa / 4.88 to 6.2 bar
 Air consumption: 5 cfm @ 80 PSI / 552 kPa
 Staple Capacity: 80
 Air Inlet: 1/4" NPT
 Tool weight: 11.5 lbs (5.2 kg)
 Pkg. weight: 23.2 lbs (10.5 kg)
 Includes: Air plug and rubber mallet
steep an angle: the fasteners can ricochet causing personal injury.
nor attempt to do so, into hard or brittle materials such as steel, concrete, or
tile.
workpiece is likely to split, allowing the fasteners to fly free or ricochet
causing personal injury.
fired fastener. Watch what you are doing & use common sense. Don't
operate any tool when you are tired or under the influence of drugs or
alcohol. Check your prescription medication to determine if there could
be a problem.
grounded surfaces: pipes, radiators, ranges, and refrigerator enclosures.
Before driving fasteners into walls, floors, or wherever "live" electrical wires
may be encountered, try to ascertain whether there is a danger of shock.
cleaned, and stored in a clean dry place out of the reach of children.
other instructions in this manual. Keep it available for use by everyone as-
signed to use this tool.
cannot cover all possible conditions and situations that occur. It must be
understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS that cannot be built into this product, but MUST BE SUPPLIED
BY THE OPERATOR.
1
1
1
1
1
1
1
1
(19 mm) long to a maximum length of 2" (50 mm)
(max. 120 PSI / 827 kPa / 8.3 bar)
11
v070601