Important Safety Instructions; Extension Cords - Rona RFS-15-1/2G-001 Guide D'utilisation

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using pneumatic tools, basic safety precautions should
always be followed to reduce the risk of personal injury.
ALL
READ INSTRUCTIONS BEFORE USING THIS TOOL
This tool was designed for installing 3/4" (19 mm) tongue and groove hardwood
flooring. We strongly recommend not to modify and/or use this tool for any
application other than that for which it was designed. If you have any questions
relative to its application, do not use the tool until you have
contacted us.
1. SAFETY GLASSES To prevent eye injuries, the tool operator and all
persons in the work area must wear approved safety glasses to ANSIZ87.1
specifications with permanently attached, rigid side shields.
2. EAR PROTECTION Wear ear protection to prevent against possible
hearing loss.
3. DRESS SAFELY. Protective gloves and non-skid footwear or safety shoes
are recommended while working with and operating this tool. Do not wear
loose clothing or jewelry. Contain long hair.
4. USE CLEAN, DRY, REGULATED, COMPRESSED AIR at 70 to 90 PSI /
488 to 621 kPa / 4.88 to 6.2 bar.
5. DO NOT CONNECT TOOL to pressure which potentially exceeds 200 PSI /
1379 kPa / 13.8 bar.
6. AIR HOSE Only use hose that is rated for a minimum working pressure of
150 PSI or 150% of the maximum system pressure, whichever is greater.
Check that connections are tight..
7. NEVER USE OXYGEN, CARBON DIOXIDE, combustible gases or any
other bottled gas as a power source for this tool. Explosion and serious
personal injury could result.
8. COUPLINGS Connect tool to air supply hose with a 1/4" NPT coupling that
removes all pressure from the tool when the coupling is disconnnected.
9. DISCONNECT TOOL FROM AIR SUPPLY HOSE before doing any
disassembly, maintenance, clearing a jammmed fastener, leaving the work
area, moving the tool to another location, or handing the tool to another
person.
10. EXTENSION CORDS: Follow carefully the instructions with air
compressors concerning the use of the correct gauge and insulation on
extension cords used outdoors.
11. NEVER USE A TOOL that is leaking air, has missing or damaged parts, or
requires repair. Make sure all screws and caps are securely tightened.
12. CHECK FOR DAMAGED PARTS. Never use a tool if safety, trigger, or
spring are inoperable, missing or damaged. Do not alter or remove safety,
trigger, or springs. Make daily inspections for the free movement of trigger
and safety mechanism.
13. REPLACEMENT PARTS. When servicing, use only identical RONA
replacement parts and fasteners recommended for your model.
14. CONNECT TOOL TO AIR SUPPLY BEFORE loading fasteners to prevent
fasteners from firing during connection. The fastener driving mechanism
may cycle when the tool is connected to the air supply.
15. ALWAYS ASSUME THE TOOL CONTAINS FASTENERS. Keep it pointed
away from yourself and others at all times. Handle the tool carefully.
Respect the tool as a working implement.
16. DO NOT LOAD FASTENERS with the hammer face depressed. The tool
may unintentionally fire a fastener.
17. DO NOT DEPRESS THE HAMMER FACE when not driving fasteners.
Never carry tool while touching the hammer face trigger mechanism; tool
may fire an unwanted fastener.
18. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across machines which are running.
19. GRIP TOOL FIRMLY to maintain control while allowing the tool to recoil
away from the work surface as the fastener is driven.
10
RFS-15-1/2G-001
!