Service Programmes - Siemens TI 905 Série Mode D'emploi

Allow the brewing unit and the
8.
interior of the appliance to dry.
Insert the brewing unit:
Push the brewing unit into the
1.
appliance in the direction of the
arrow. The arrow is located on the
top of the brewing unit.
Position the brewing unit from
above, suspend on the guide rails
and push into the appliance.
Slide the red lock to the left across
2.
the brewing unit.
Insert the coffee grounds slider (red)
3.
and the brewing unit cover (red).
Insert the cover until it engages.
4.
Insert the water tank.
5.
.

Service programmes

Every so often – the exact frequency
S e r v i c e p r o g r a m m e s
depends on usage and water hardness
– one of the following messages will
appear in the display in place of the
coffee selection:
Rinse milk system
■
Run descaling program urgently!
■
Run cleaning program urgently!
■
Run calc'nClean program urgently!
■
The appliance should immediately be
cleaned or descaled using the
appropriate programme. Alternatively,
the two processes Descale and Clean
can be carried out together using the
calc'nClean function. Failure to carry out
the service programme according to the
instructions may damage the appliance.
You can also start the service
programmes at any time without having
to wait for a reminder to appear in the
display. Press the $/± button, select the
desired programme and run it.
Service programmes en
Notes
Important: If descaling is not
■
performed on the appliance in good
time, then the following appears
"Descaling programme overdue.
Device will shortly be locked!".
Immediately perform the descaling
process in accordance with the
instructions. If the appliance is
locked, it can only be operated
again once the descaling process
has been carried out.
Caution: For each of the service
■
programmes, use descaling and
cleaning agents as described in the
instructions and observe the
(relevant) safety information.
Do not drink the liquids.
■
Never use vinegar, vinegar-based
■
products, citric acid or citric
acid-based products for descaling.
For cleaning and descaling only use
■
the tablets intended for such. The
tablets were specially developed for
this appliance and new stocks can
be ordered through customer
service. ~ "Accessories"
on page 11
Never insert descaling tablets or
■
other media into the grounds
compartment.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Rinse the
milk system.
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion to
form.
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use.
27