Yamaha AirWired TSX-W80 Mode D'emploi page 12

TROUBLESHOOTING
iPod™
Problem
The iPod does not charge up.
No sound
Cannot change the volume
by changing the volume of
the iPod.
The iPod display does not
change by pressing the
remote control volume keys.
Suddenly the speaker
produces sound even though
an iPod is not connected.
Transmitted sound is cut.
(Status indicator of
transmitter flashes green and
iPod indicator of SOURCE
on unit flashes.)
10
En
Cause
The iPod connecting to the transmitter is
set in the charging cradle improperly.
The iPod is not connected to the
transmitter firmly.
Earphones are connected.
Distance between the unit and the iPod is
too far.
The battery of the iPod is low.
The iPod software version has not been
updated.
The iPod is in the process of connecting
with the unit.
The unit and transmitter are not
connected since they are set to different
groups.
The unit is connected to another unit.
– The iPod is not supported by this unit.
– The iPod is not connected correctly.
– The iPod software version is out of
date.
– The transmitter is connected to several
units.
The unit is connected to another
transmitter.
The signal from the transmitter is
blocked by your body or metallic objects,
etc.
There is a device (microwave oven,
wireless LAN, cordless telephone, etc.)
outputting signals in the 2.4 GHz
frequency band nearby.
If noise occurs at the same frequency the
transmitter is using, the unit will search
and move to another (unused) frequency,
which may cause sound to be cut.
Solution
Remove the iPod connecting to the
transmitter from the unit, then set it in the
charging cradle again (☞ P. 2).
Connect the iPod firmly.
Remove the earphones.
Move the transmitter closer to the unit.
Charge the iPod.
Download the latest iTunes software to
update the iPod software version to the
latest.
Please wait for a while.
Set both the unit and transmitter to the same
group (☞ P. 7).
Select a different group by changing the
group setting of the unit and transmitter
(☞ P. 7).
– Use the supported iPod.
– Connect the iPod firmly.
– Update the iPod software version to the
latest.
If the problem cannot be solved, even the
latest software, reset the iPod.
– Change the group setting (☞ P. 7).
Change the group setting (☞ P. 7).
Change the way of holding, the orientation,
or the position of the transmitter to avoid
your body or metallic objects blocking the
signal.
Place the unit away from these devices, or
turn them off. If the device is IEEE802.11n-
compliant, change the channel setting of the
device so as not to affect the unit.
This is not malfunction. If cut occurs
frequently, relocate the unit.