Festo VPEV-1/8-M12 Notice D'utilisation page 16

VPEV-1/8-M12
Electric components
S
Use an angle connector as described in the section "Accessories."
S
Make sure that the cable is laid so that it
is:
– not squashed
– not bent
– not tight.
S
Fasten the angle connector so that the
pneumatic and electric cables do not
cross each other.
S
Connect the VPEV-... as follows:
Pin no.
1
2
3
4
*)
If the connecting socket is used as described in the section "Accessories."
Please note here that:
– the cables must not be squashed
– the max. tightening torque of the union nut is 0.5 Nm (tighten by hand).
Festo 0007NH– English
Connections Cable colour
Switchable voltage: brown
AC 0...48 V
DC 0...48 V
Output of normally- white
closed contact
Not assigned ---
Output of normally- black
open contact
Fig. 5
Fig. 6
*)
Pin assignment
16