Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Loosen turntable locking screw (grey arrow).
2. Set turntable to required angle.
The scale on the saw table indicates the set
angle.
3. Tighten turntable locking screw.
The actual cutting operation is the same as
described under "Standard cross cuts"n.
Bevel cuts
3
With a bevel cut the workpiece is cut at an
angle between 0° and 45° to the vertical axis.
Starting position:
− Sawhead fully lifted
(if necessary, pull out locking pin);
− Turntable locked in the 0° position.
1. Loosen sawhead tilt lock lever on rear of saw.
2. Tilt sawhead to required angle.
KS 210 / KS 210 HM Plus
3. Tighten lock lever.
The actual cutting operation is the same as
described under "Standard cross cuts".
Compound mitre cuts
3
A compound mitre cut is the combination of
mitre and bevel cut. Here the workpiece is cut
at an angle other the 90° across its width and
at the same time cut at an angle other than
90° vertical through its surface.
Starting position:
− Sawhead fully lifted
(if necessary, pull out locking pin);
− Set turntable to desired position.
− Tilt sawhead to desired bevel angle.
Execution:
The cutting operation is the same as described in
„standard cross cuts".
Care and maintenance
A
Danger!
Prior to all servicing:
− Switch machine OFF.
− Unplug power cable.
− Wait until the saw has come to a complete
stop.
• Check that all safety devices are operational
again after each service.
• Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equipment
maker can cause unforeseen damage.
• Repair and maintenance work other than
described in this section should only be carried
out by qualified specialists.
Saw blade change
A
Danger!
Directly after cutting the saw blade may be
very hot – risk of burns! Let a hot saw blade
cool down. Do not clean the saw blade with
combustible liquids.
Risk of injury, even with the blade at stand-
still. Wear gloves when changing blades.
On re-assembly observe direction of rotation
of inner blade collar, saw blade and outer
blade collar!
2.23
Publicité
Table des Matières
