Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turntable
After loosening the locking screw at the saw's base
the turntable can be set. By this means the cutting
angle is adjusted against the guide edge for mitre
cuts. In both directions an angle of up to 45° is pos-
sible.
Locking pin
With the locking pin the sawhead can be locked in
the "down" position. This can be useful after work is
finished or for transportation.
2.20
Lock knob
With the lock knob the saw blade is locked for a
blade change.
A
Danger!
Never press the lock knob if the power supply
cable is still plugged in or the saw blade still
turning! The locking device can be damaged
when it is engaged with the saw blade still
turning.
• Lock knob KS 210:
• Lock knob KS 210 HM Plus:
KS 210 / KS 210 HM Plus
Publicité
Table des Matières
