FISCHER Komfort Mode D'emploi page 12

Assembly
GB
Stepp 9
Fixing the lamps
IMPORTANT:
Step 10
Attaching the coupling
Step 11
Attaching the trailer
to the cycle
Securing the coupling
Dealing with the
belt system
86388-FIS-IM-V03-INT-OEF.indd 12
Attach the front lamp (7) on the outer frame/wheel
arch (3) at the front in the direction of travel on the left
with the bracket provided on the trailer for this purpose.
(Picture 1). Attach the rear lamp (7) on the outer frame/
wheel arch (3) at the rear in the direction of travel on the
left with the bracket on the trailer. (Picture 2).
The 2 white front reflectors and the 2 red rear reflectors
are already fitted on the hood. The wheel reflectors are
likewise pre-fitted in the wheel.
The lamps are only compliant with German Road
Traffic Licensing Regulations (StVZO) when operated
with rechargeable batteries. They must always been
kept clean and fitted with batteries (not included) with
sufficient charge. To check the power there are
indicators on all the lamps that light up as soon as the
light output becomes weak. In this case the batteries
must be recharged as quickly as possible.
In order to remove the trailer coupling (B), undo the bolt
with its securing clip (C) in the towbar and pull out the
bolt. Now you can pull the trailer coupling (B) out of the
towbar. Fitting it to the back axle of the cycle: With
axles with quick-release, remove the entire axle, push
the trailer coupling (B) on to the nut and fit the axle back
on. With axles with attachment by hex nuts, screw off
the nut with its washer. Put the trailer coupling (B) on to
the axle and screw the nut back on with its washer.
Connect the coupling unit (B) to the towbar with the
trailer coupling (A) attached to the cycle and secure it
with the bolt (C).
IMPORTANT: Make sure that the bolt is properly
secured. (The clip must be attached).
Once the towbar has been attached, pull the safety
strap through the rear stay of the cycle and hook it
into the bracket on the towbar (see Fig.).
IMPORTANT: The connection between the cycle and
the trailer is the most important process in the
attachment procedure. Make quite sure that the trailer
is securely connected to the cycle.
Note: The trailer is fitted with safety locks that can
only be unlocked when the centrally located locking
mechanism is released by being pressed in at the
same time.
Transporting one child: When transporting one child,
he/she should be placed in the middle of the trailer
and belted in by means of the middle lap belt and the
two middle belts on the seat-back. Adjust the belt
lengths so that the child is securely held in the seat
and that belts cannot be slipped off.
1 2
A
A
B
C
07.01.16 10:22