Arktic 271773 Mode D'emploi page 8

Operation
• Before first use, clean the appliance interior and
exterior surface with lukewarm water and a soft
cloth.
• Position the appliance in a well-ventilated place,
leaving at least 150 mm gap around all sides for
ventilation purposes.
• Let the appliance stand alone for about one hour
in order to settle the refrigerant. Make sure con-
nect properly with the water supply system.
• Then, plug in to a suitable socket.
• Press down the ON / OFF switch (1) on the control
panel in order start up.
• Then, the appliance will use water to clean up
inside and water will flow out automatically. This
time. the 3 light indicators "
lights up & blink for about 30 seconds.
• Also, the ON / OFF switch (1) lights up in green.
The appliance starts to operate.
• The ice cubes making process is completely au-
tomatic, it consists of several stages as below:
Water inlet = = > ice cubes production = = > ejec-
tion of ice cubes = = > storage of ice cubes.
• Then, push the slide door (4) and use ice scoop
EN
(16) to take out the ice.
• When the ice storage container is full, the "
indicator will light up in yellow and the appliance
will stop operation automatically.
• Once the ice cubes have been removed, the appli-
ance continue production of ice tubes automat-
ically.
Cleaning & Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning or doing repair or maintenance work. And this should be performed by qualified and authorized
technician only.
Cleaning
• Clean the appliance thoroughly after each use
and after long period.
• The exterior and interior surfaces can be cleaned
with a damp cloth and a little detergent.
• Do not use water jet or steam cleaner for clean-
ing and do not immerse the machine under the
water.
8
• Note: For sanitary reasons, you should dispose of
• If the water supply is insufficient, the "
• If any error or failure occur, the "
• Switch OFF the appliance by pressing down the
", " " and " "
Notes:
• DO NOT switch ON again the appliance imme-
• Check the connectors of the water inlet and out-
"
• If the appliance is not used for a long period of
• Clean the condenser for every 2 ~ 3 months.
• Use soft cloth only and make sure you never use
• After the cleaning procedure, you should use a
the ice cubes produced in the first cycle for every
use. Do not use them for beverages or cooling
food.
dicator will light up in yellow and the appliance
will stop operate automatically. Check the water
supply (hose) connected to the appliance.
will light up in red and the appliance will stop op-
eration automatically.
ON / OFF switch (1) and unplug it from the elec-
trical supply when not in use.
diately after shut down automatically (caused
by insufficient water supply, ice cube container
too full, current interruption). Wait at least 3 ~ 5
minutes in order to avoid damages to the com-
pressor.
let hose regularly for the leakage or overflow of
water that may be present.
time, screw off the drainage cover (12) at the rear
of the appliance. Wipe dry the water tank using a
dry, clean cloth.
any kind of abrasive agents or pads, which could
scratch the surface.
soft and dry cloth to wipe dry and polish the sur-
face.
" in-
" indicator