Operating Instructions; Vacuum Packaging With A Bag - REBER 9718 N V-Home Manuel D'utilisation

EN
C. OPERATING INSTRUCTIONS
I. Making a bag with bag roll
1. Pull out the bag material and cut the suitable length.
2. Put one end of the bag on top of the sealing element.
3. Close the cover and press handle to lock the cover.
4. Press "Seal" to start welding. The indicator lights on to indicate sea-
ling operate.
5. When the indicator turns off, the sealing is done; unlock the handle to
open the cover and take the bag; it is ready for vacuum/sealing.
N.B.: to improve welding operation, it is possible to operate "Pulse" fun-
ction before starting welding operation.
II. Vacuum packaging with a bag
1. 1. Put the items inside the bag. For best result leave 4/5 cm. free
space on top of the bag.
2. Clean and straighten the open end of the bag, make sure no dust,
wrinkle or ripples.
3. Place the open end of the bag within the vacuum chamber area.
Make sure the air intake is not covered by the bag.
4. Put the cover down and press handle to lock the cover.
5. Press switch (1.) "Auto/Vac - Cancel" to start automatic vac/welding
operation.
6. Wait until RED light (2.) turns off to cpmplete operation. Then
operate the handle to unlocj the cover and remove bag.
N.B.: You can operate at any time, during vac/welding operation:
• Stop any operation by switching (1.) "Auto/Vac - Cancel".
• Start welding by switching (2.) "Seal"
ATTENTION:
• Wipe out any excess liquid or food residue in the vacuum cham-
ber or bag before each vacuum operation.
• Clean liquid container (11.) after each vacuum operation.
• This device will not provide vacuum with smooth bags. Embos-
sed bags must be used.
18