Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VS16 BLANC blanc
1.
Clamping ring grilles
2.
Front grille
3.
Fan fastener
4.
Fan blades
5.
Grille fastener
6.
Rear grille
7.
Motor housing
8.
Buttons
9.
Oscillate button
10. Fastening bolt
11. Adjustable standard part
12. Clamp coupling
13. Bottom support
14. Covering cap
15. Base
Assembly
For all models
1.
Unscrew the grille fastener anticlockwise to detach it from the front of the motor
housing.
2.
Mount the rear grille against the front of the motor housing (VT 9 & 16: with the
grip facing forwards!), so that the pins in the motor housing fit into the holes in
the grille.
3.
Screw the grille fastener firmly clockwise onto the protruding screw thread of the
motor housing.
4.
Remove the PVC socket from the motor spindle and throw it away.
5.
Press the fan blades onto the motor spindle, with the notches over the pins.
VT12 blanc & VT16 blanc
6.
Screw the fan fastener firmly anticlockwise onto the end of the motor spindle.
7.
Unscrew the clamping ring screw nearly all the way and mount it loosely with
the rearmost slot around the rear grille. Now position the front grille onto the
rear grille, in the front slot of the clamping ring. Tighten the screw firmly; this
clamps the grille parts together.
Now place the VT models upright; they are ready for use.
VS16 blanc
8.
Place both base parts crosswise over each other.
9.
Place the bottom support on the base, holes over holes, and screw the base and
support tight with the four bolts.
10. Pull the adjustable standard part out of the bottom support to the required height
and fix this height by firmly tightening the clamp coupling.
14
Publicité
Table des Matières
