Setting The Valve Lift; Activating Full-Stroke Mode; Activating The Default Stroke Mode - Honeywell HR 40 Instructions De Montage Et D'utilisation

Setting the valve lift

The HR 40 operates with a factory setting with the optimum valve lift that is
required for room temperature control.

Activating full-stroke mode

If the entire valve stroke is to be used or if the valve does not close
completely, activate the full-stroke mode.
Note: The battery life is reduced through the full-stroke operating mode.
1. Remove the operating unit.
2. Press and hold the
lantern until the stop is reached and lock.
full is displayed.

Activating the default stroke mode

1. Hold the button down.
PROG
2. Slide the operating unit onto the valve lantern until the stop is reached and
lock.
Def is displayed.
button and slide the operating unit onto the valve
41