Wiring Instructions; Wiring Connections - Dedicated Micros 2020/300 Manuel D'installation

5. Wiring instructions

Wiring connections

Electrical connections to the Type 2020 I.R.
illuminator are made via a terminal block situated
inside the rear polycarbonate photo-electric switch
enclosure as shown in fig.5. Access to which is
achieved by unscrewing the four captive cover fixings
and removing the cover as shown in fig.6. Using a
suitable 3 core x 0.75mm
cable (Dedicated Micros recommend the use of a
silicon covered cable due to the extreme
temperatures generated by the illuminator) prepare
the cable end for connection and feed the cable
through the spare cable gland and terminate as
shown in figs 7 & 8. Replace and secure the cover to
finish. The cable gland should be tightened
sufficiently to ensure that any strain put upon the
cable is not transmitted to the terminal connections
and that a watertight seal is achieved. It is
recommended that the incoming electrical supply is
protected by a fuse rated at 2 Amp for a type
2020/300 (300Watt) and 3 Amp for a type 2020/500
(500Watt) illuminator.
Fig.8
Photoelectric
Switch
Terminal block
Type 2020 Installation Manual
2 230V.ac rated outdoor
230V.ac Customer input
Fig.5
Fig.6
Fig.7
Page. 4