Threading; Bobbin Winding - Brother PQ1500S Manuel D'utilisation

Threading (1)

Bobbin Winding

Do not move bobbin winding clutch while machine
is running.
3
4
3
3 Pass the thread through the triangu-
lar hole.
Note
1
2
5 - 0: See the following illustrations.
4 Pass thread through bobbin winding
thread guide as shown in drawing.
]1
Spool Cap
Spool of Thread
1 Raise the thread guide bar all the way.
2 Mount a spool thread on the spool pin.
✽1 Use spool cap when using parallel-wound thread.
✽2 Use spool cushion when using cross-wound thread.
Thread Notch 1
Thread Notch 2 Bobbin
Bobbin Winder
Shaft
Guide Pin
5 Run thread through top thread notch
1, and align bottom thread notch 2 of
the bobbin with guide pin on bobbin
winder shaft.
2
]2
Spool Cushion
Bobbin Winding Clutch
6 Press bobbin winding clutch up
against empty bobbin. If the bobbin
stop does not slide easily between
the top and bottom of the bobbin,
check that the bobbin is seated prop-
erly with the guide pin (5) inserted
into the lower notch.
1
7