Connecting To An Ethernet Network - Dedicated Micros Eco4 Guide D'installation

Relay connections are as follows:
Pin Connection
1-2 Relay 1
3-4 Relay 2
5-6 Relay 3
7-8 Relay 4
Important Note: The onboard relays are rated at 24V 500mA, do not attempt to
connect mains power through the relays.

Connecting to an Ethernet network

Eco4 can be connected to a standard 10-baseT Ethernet network allowing full
control of the Eco4 from a remote location.
Network connection
To connect a Eco4 to a network you will need the following items:
• A spare 10-baseT network point.
• A RJ-45 network cable (CAT5 or equivalent).
• A static IP address and Subnet mask (some networks may also require a
Default gateway, consult the network administrator for advice).
To configure the Eco4 on the network you will need to perform the following
steps:
1. Enter the Eco4 menu (press and hold the menu button).
2. Tap the menu button until the 'System Options' page is displayed.
3. Use the cursors to select 'Network settings'
4. Enter the 'Network settings' menu by highlighting 'Edit' and pressing the up
or down cursor.
Action
Close on Alarm
Close on Activity Detection
Close on Camera fail
Undefined
5. Enter the IP address, Subnet mask and Default gateway in the spaces.
Note: The addresses are four sets of three digits, if you have only two digits in
the address insert a 0 before the number i.e. 123.123.123.001
6. Press the menu button to exit the menu.
7. Press camera 1 to accept the changes and reboot the system, or press menu
again to exit without changing the settings.
Viewing images across the network
Eco4 can use either a web browser or Network Viewing Software to view images
across the network. The Network Viewing Software can be downloaded from the
unit onto your local PC using the network connection.
To download the network viewing software:
1. Open your web browser software on your PC.
2. Enter the IP address of the Eco4 in the 'Address' box in Internet Explorer or
Netscape and press Enter. Remove all preceding 0's, i.e. 123.123.123.001 in
the Eco4 should be entered as 123.123.123.1 in the web browser.
3. A web page from the Eco4 is loaded. Click on the 'PC viewer application' icon,
you will be prompted to Save or Run the program.
4. Select 'Run this application from its current location'.
5. The software will download and install, follow onscreen prompts.
6. The program can be found in Start>Programs>DM Network Viewer.
Details of using the Network Viewing Software can be found in the 'User Guide'
in the Network Viewing Software folder.
The minimum specification PC for viewing images over a network is:
• 500Mhz CPU
• 64MB RAM
• 4MB video card (capable of 16 million colours)
• Minimum of 800x600 screen resolution
7