Zircon LASERVISION 6.0 Mode D'emploi page 8

Figure 10: Calibrating to Level
on
1a
off
3 sec
1b
B
Calibrating to Plumb
• Place the LaserVision against a stable, nearly vertical surface (See note (1) above).
• Press and hold the ON/OFF button for about three seconds until the bars start
moving up and down (Figure 9, page 7) and an audio tone sounds. The axis
arrow and the number 1 will blink while the LaserVision is calibrating the first
position.
• When the indicators stop moving and the second audio tone sounds, the number 2
will appear. Rotate the LaserVision 180 degrees while keeping the same end up
(Figure 11 below).
on
off
2a
3 sec
Figure 11: Calibration to Plumb
A
A
B
on
off
A
2b
A
B
B
on
off
8