Customer Service - Zircon LASERVISION 6.0 Mode D'emploi

LIMITED 1 YEAR WARRANTY
Zircon Corporation ("Zircon") warrants this product to be free from defects in
materials and workmanship for one year from the date of purchase. Any in-war-
ranty defective product returned to Zircon*, freight prepaid with proof of pur-
chase date and $5.00 to cover postage and handling, will be repaired or replaced
at Zircon's option. This warranty is limited to the electronic circuitry and origi-
nal case of the product and specifically excludes damage caused by abuse,
unreasonable use or neglect. This warranty is in lieu of all other warranties,
express or implied, and no other representations or claims of any nature shall
bind or obligate Zircon. Any implied warranties applicable to this product are
limited to the one year period following its purchase. IN NO EVENT WILL
ZIRCON BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM POSSESSION, USE OR
MALFUNCTION OF THIS PRODUCT.
In accordance with government regulations, you are advised that:
(i) some states do not allow limitations on how long an implied warranty lasts
and/or the exclusion or limitations of incidental or consequential damages, so
the above limitations and/or exclusions may not apply to you, and further (ii)
this warranty gives you specific legal rights and you may also have other rights
which vary from state to state.
Zircon Corporation
Attn: Returns Department
9731 Siempre Viva Road, Suite B & C
San Diego, CA 92173, U.S.A.
Tel: (800) 245-9265 or (408) 866-8600

Customer Service

When customer service is required within one year of original purchase, send
the LaserVision product to Zircon Corporation, freight prepaid.
All LaserVision products returned for service must include your return address
and a check or money order for $5.00 to cover postage and handling. Requests
for in-warranty service must include proof of purchase (dated sales receipt, etc.).
Out-of-warranty service and repair, where proof of purchase is not provided,
shall be returned with repairs charged C.O.D.
FCC Part 15 Class B Registration Warning
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
(1) Reorient or relocate the receiving antenna.
16