DeWalt DC330 Guide D'utilisation page 14

1. Lift the keyless blade lever (E) as shown in Figure 5.
FIG. 5
E
K
2. Insert the T-shank blade into the clamp mechanism (K) while
guiding the back of the blade into the groove of the guide
rollers (L).
3. The T-shank should be completely inside the clamp mechanism as
shown in Figure 5.
4. Release the keyless blade lever.
TO REMOVE A BLADE
1. Lift the keyless blade lever (E).
2. With a slight shake the blade will drop out.
K
L
Beveling the Shoe (Fig. 6)
To unlock the shoe, pull the keyless bevel lever (F) to the side.
To lock the shoe, push the keyless bevel lever back under the body
of the jigsaw.
FIG. 6
F
TO BEVEL THE SHOE
1. Unlock the shoe.
2. Slide the shoe (G) forward to release it from the 0° positive stop
position.
3. The shoe can be beveled to the left or to the right and has detents
at 15°, 30° and 45°. The shoe can be manually stopped at any
degree between 0° and 45°.
4. Once the desired bevel angle is achieved, lock the shoe into
place.
TO SET SHOE BACK TO 0°
1. Unlock the shoe.
12
G