DoorBird D21 Série Manuel D'installation page 7

DEVICE EXAMPLE WITH INFO MODULE
AND KEYPAD MODULE
Front
1
2
3
4
5
6
7
8
1) Night Vision LEDs
2) HDTV Video
3) Microphone
4) Light Sensor
For night-vision mode
5) Security screws
6) Loudspeaker
12
9
10
7) RFID Reader
8) Motion Sensor
9) Info Module
10) Keypad Module
The illumination is also acting as
Diagnostic LED(s)
Inside
VIDEOS
Need help with the installation? Be sure to watch our installation videos which
can be found on http://www.doorbird.com/support
Each individual step of the installation is clearly documented in the videos.
INSTALLATION
All the steps below should be carried out carefully by a competent adult, taking
into consideration any applicable safety regulations. Please contact us directly
or seek the advice of a compeent specialist.
Please ensure that all wires used for the installation are undamaged along
their entire length and approved for this type of use.
Network speed and network components
Please ensure that the upload speed of your Internet connection is at least 0.5
Mbps. You can also carry out a speed test at any time via the DoorBird App.
The user experience is only as good as your network speed, network stability
and quality of your network components, such as your Internet Router and
WiFi access points or WiFi repeaters. Please also make sure that your network
components are no older than two years old, have been manufactured by a
well-known manufacturer, and have the latest firmware installed.
1) Main Electrical Unit
1
2) Yellow cable for call button
2
(unused)
3
3) Red cable for Module Port 1
4
Connected to the Keypad Module
5
4) Green cable for Module Port 2
Connected to the Info Module
6
5) Screw connection terminal
7
6) LAN/PoE jack
7) Nylon cord
To secure the front panel during
assembly
13