Star TSP800 Série Mode D'emploi page 7

Always use all eight (8) screw holes in the mounting bracket when
securing the mounting bracket to the wall.
Mount the bracket to the wall so that its mounting accuracy is within
a range of ±2° perpendicular.
The wall used for mounting should be 90°±2° to the horizontal
reference.
1-2-1. Specifications of the wall mounting bracket
Wall mounting bracket
outer dimensions
Wall mounting bracket
weight
Screws for wall mounting
bracket
• Not included in the
package. The customer
is to prepare the screws
that meet the type of
wall to be used for
mounting.
1-2-2. Mounting the bracket for the wall mount model
1 Make sure there is enough room for
the printer with the printer cover open,
especially in front of the printer.
2 As shown in the illustration to the
right, place the mounting bracket
against the wall where the printer is to
be mounted and mark the positions of
the screw holes.
3 Drill holes at the locations marked.
4 Secure the bracket in place using
screws with a diameter of 4 mm.
121 × 168 × 14.5 mm (Width × Height × Depth)
Approx. 0.27 kg.
Wood structure wall
Concrete wall
– 4 –
The eight (8) screws
used must have both a
shear and tensile
strength capable of
withstanding a load of
12 kgf (118 N) or more
The anchor nuts used
must have both a shear
and tensile strength
capable of withstand-
ing a load of 12 kgf
(118 N) or more
Wall mounting
bracket
Use commercially
available screws that
have sufficient
strength to withstand
the weight of the
printer.
Wall material