Appendix E: Periheral Unit Drive Circuit - Star TSP800 Série Mode D'emploi

Appendix E: Periheral Unit Drive Circuit

Peripheral Drive Connector
Signal
Pin No.
name
1 FG Frame ground
2 DRD1 Drive signal 1
3 +24V Drive power
4 +24V Drive power
5 DRD2 Drive signal 2
6 DRSNS Sense signal
Modular plug
Modular plug: MOLEX 90075-0007,
AMP641337, or JAPAN BURNDY B-66-4
Notes 1. A shield cable must be used.
2. It is not possible to drive two drives simultaneously.
3. The peripheral drive duty must satisfy the following:
ON time / (ON time + OFF time) ≤ 0.2
4. The resistance of the peripheral drive solenoid must be 24 Ω or
higher.
If it is lower than 24 Ω, over-current may flow into the solenoid,
causing the solenoid to burn.
I/O
Function
direction
—
OUT
OUT
OUT
OUT
IN
– 110 –
6
<Viewed from Connector Surface>
Shield
1
Wire lead