Settings; Fitting The Splinterguard; Fitting The Chip Guard; Dust Extraction - Festool TRION PS 300 Q Notice D'utilisation D'origine

WARNING
Risk of injury, electric shock

Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
Connecting and detaching the mains power cable
[1-3] see Fig. [2a].
PS 300 Q, PS 300 EQ
The power tool has a slide switch to switch the tool
on and off (I = ON, 0 = OFF).
PSB 300 Q, PSB 300 EQ
The power tool have a push button switch [2-2] to
switch the tool on and off.
The locking button [2-1] can be engaged to operate
in continuous mode. Press the switch again to re-
lease the knob.
7

Settings

WARNING
Risk of injury, electric shock

Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
7.1 Changing tools

Open chuck lever [3-4] up to the stop.

Remove fitted saw blade.

Insert new saw blade up to the stop in the saw
blade holder [3-1].

Close chuck lever.
7.2 Adjusting three saw blade guide
The pendulum jigsaws have an additional hard
metal guide [3-2] immediately above the workpiece
for a better guidance of the saw blade.

Tighten the screw [3-3] with the Allen keyl [1-4]
until the jaws almost rest against the saw blade.
The saw blade should still be able to be
moved easily!
7.3

Fitting the splinterguard

The splinterguard allows cuts with splinter-free
edges, even on the exit side of the saw blade.

With the tool switched off, fit the splinterguard
[4-3] on the guide [4-2] up to the saw blade,

switch the jigsaw on,

with the tool running, push the splinterguard in
until the splinterguard is flush with the front
edge of the base runner. Thereby the splinter-
guard is cut in.
 The splinterguard must lie close to the saw
blade on both sides to ensure its reliable opera-
tion. Thus, a new splinterguard should be fitted
every time the saw blade is changed to ensure
splinter-free cuts.
7.4

Fitting the chip guard

The chip guard prevents chips from flying off and
improves the efficiency of the chip extractor.

Insert the chip guard [2-8] between the base
runner and chuck lever,

push back the chip guard with a slight pressure
until it catches in place.
7.5

Dust extraction

WARNING
Dust hazard

Dust can be hazardous to health. Always work
with a dust extractor.

Always read applicable national regulations be-
fore extracting hazardous dust.
Jigsaws can be connected to a dust extractor (hose
diameter 27 mm) using the extractor adapter [2-4].
 When working with suction units, always use a
splinterguard in order to prevent the suction
channels becoming blocked.

Insert the extractor adapter into the rear hole of
the base runner in so that the hook [2-6] catch-
es in the notch [2-7].

Press the lever [2-5] to remove the extractor
adapter.
7.6

Adjusting the base runner

The base runner can be swivelled to both sides by
up to 45° for bevel cuts.

Remove chip guard and splinterguard,

release locking screw [4-1] with Allen key [1-
4],

push base runner approx. 5 mm forwards,

set desired inclination according to the scale [5-
2],

tighten locking screw [4-1].
The base runner can be moved back for sawing
close to edges.

Remove chip guard and splinterguard,

release locking screw [4-1] with Allen key [1-4],
TRION
GB
13