Optimate MILENCO 6 TM424 Mode D'emploi page 6

vehicle's wiring system, it may be signalling a loss of current through deteriorated wiring or a degraded switch
or contact, or in‑circuit current‑consuming accessories. Always remove the battery from the vehicle, reconnect
the Milenco 6™ and allow it to proceed through its programme once more. If a better test result is now
obtained, this suggests that the power losses are partly due to an electrical problem in the electrical system and
not in the battery itself. If the poor result persists, you are advised to take the battery to a professional service
workshop equipped with professional equipment for a more thorough investigation.
4.2 Maintenance - float charge at a safe voltage limit of 13.6V and up to 0.8A is available to counter self-
discharge.
The battery can draw current as required to support small loads and counter self-discharge. If the battery voltage
falls below 12.4V the program reverts to step 3.3.
Maintaining a battery for extended periods:
good, for months at a time. At least once every two weeks, check that the connections between the charger and battery
are secure, and, in the case of batteries with filler caps on each cell, disconnect the battery from the charger, check the
level of the electrolyte and if necessary, top up the cells (with distilled water, NOT acid), then reconnect. When
handling batteries or in their vicinity, always take care to observe the SAFETY WARNINGS above.
Charging time:
The time required for the Milenco 6 to complete a charge on a flat but otherwise undamaged battery
is roughly equal to the battery's Ah rating, so a 10Ah battery should take no more than about 10 hours to progress to
Step 4. Deep-discharged batteries may take significantly longer.
LIMITED WARRANTY
MILENCO LIMITED, BLACKHILL DRIVE, WOLVERTON MILL, MILTON KEYNES, MK12 5TS, United Kingdom, offers this limited
warranty to the original purchaser at retail of this product. This limited warranty is not transferable. Milenco Limited
warrants this battery charger for three years from date of purchase at retail against defective material or workmanship. If
such should occur the unit will be repaired or replaced at the option of the manufacturer. It is the obligation of the purchaser
to forward the unit together with proof of purchase (see NOTE), transportation or mailing costs prepaid, to the manufacturer
or its authorized representative. This limited warranty is void if the product is misused, subjected to careless handling, or
repaired by anyone other than the factory or its authorized representative. The manufacturer makes no warranty other than
this limited warranty and expressly excludes any implied warranty including any warranty for consequential damages.
THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES ANYONE
TO ASSUME OR MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN THIS EXPRESS LIMITED WARRANTY.
YOUR STATUTORY RIGHTS ARE NOT AFFECTED.
The Milenco 6 will maintain a battery whos basic condition is
6