Maintenance And Cleaning; Disposal - Renkforce 1007598 Notice D'emploi

14. Maintenance and Cleaning

The product is maintenance-free for you. Servicing or repair must only be carried out by a specialist or
specialist workshop. The product contains no parts that require servicing by you. Therefore, do not open/
disassemble it.
Before cleaning the product, wait until it has fully cooled off.
A dry, soft and clean cloth is sufficient for cleaning the outside. Do not push the surface of the motion
detector's diffuser, the LC display or the camera lens too hard; this may cause scratches.
Never point the water jet of a garden hose or a high-pressure cleaner or similar at the surveillance came-
ra.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since
these may damage the casing or even impair function.

15. Disposal

Electrical and electronic products must not be disposed of in domestic waste.
Dispose of the product according to the relevant statutory regulations at the end of its service
life.
44