Setting The Time And Date; Setting Mains Frequency - Renkforce 1007598 Notice D'emploi

c) Setting Time and Date
Time and date must be set so that the surveillance camera can display this information in pictures and
videos. This way, you can tell later when a picture or video has been recorded.
Note:
Settings are not possible while a recording is running.
• Briefly push the button „M" (9), the camera icon will flash at the upper left of the display.
• Push the button „8" (10) 5 times in sequence until „T" and the left part of the time „00-00" flash in the
display.
• Briefly push the button „5" (12) for confirmation.
• Set the hours with the buttons „8" (10) and „2" (11).
• If you briefly push the button „5" (12) for confirmation; „T" and the minutes will flash in the display.
• Set the minutes with the buttons „8" (10) and „2" (11).
• If you briefly push the button „5" (12) for confirmation; „D" and the month will flash in the display.
• Set the month with the buttons „8(10) and „2" (11).
• If you briefly push the button „5" (12) for confirmation; „D" and the date will flash in the display.
• Set the date with the buttons „8(10) and „2" (11).
• If you briefly push the button „5" (12) for confirmation; „D" and the year will flash in the display.
• Set the year with the buttons „8" (10) and „2(11).
• Briefly push the button „5" (12) for confirmation.
• Briefly push the button „M" (9) to leave setting mode.
d) Setting Mains Frequency
Here you can select the frequency of your mains voltage (in Europe, this is usually 50 Hz). Luminescent
tubes may otherwise flicker or pictures may be over-exposed.
Note:
Settings are not possible while a recording is running.
• Briefly push the button „M" (9), the camera icon will flash at the upper left of the display.
• Briefly push the button „8" (10) 6 x until „50HZ" or „60HZ" flashes in the display.
• Briefly push the button „5" (12) for confirmation.
• Set the mains frequency with the buttons „8" (10) and „2" (11). In Europe, always set „50HZ".
• Briefly push the button „5" (12) for confirmation.
• Briefly push the button „M" (9) to leave setting mode.
37