Velleman LABPSHH01 Mode D'emploi page 7

Recall Saved Data
1. In normal operating mode, press the STORE/RECALL button to open
the memory banks.
2. Select your memory bank with
3. Press SET to load the selected memory bank.
5.7 Voltage and Current Calibration
Connect the output terminals to a 5-digit voltage meter, current meter or
10 Ω/100 W resistance.
1. Connect the output terminal to an external reference voltage or
current meter.
2. Press V/A to switch to voltage or current mode.
3. Use the keys to adjust the displayed value to correspond with the
reference voltage or current.
4. Press SET to confirm.
5.8 Backlight
In normal operating mode, press
deactivate.
V. 03 – 28/10/2016
LABPSHH01
or .
to activate the backlight; press
7
to
©Velleman nv