Medion Life P14325 Guide De Démarrage Rapide page 99

TV switches off
No reception/poor reception
via a wireless network
connection (WLAN).
WIRELESS DISPLAY cannot
be established.
The remote control is not
working.
Menu cannot be opened.
Filter function of the
channel list does not work
permanently.
No Bluetooth® connection
For further information on troubleshooting, read where applicable the comprehensive
operating instructions available online because certain measures and procedures are
described there in more detail.
16
• Check whether the automatic TV switch off function is
activated under
MORE...
• Ensure that all necessary settings have been made.
• Check that all necessary settings have been made. Read the
section "Wireless Display".
• Check whether the batteries in the remote control are
functional and have been inserted the right way round.
• Ensure the sensor field is not exposed to strong light.
• Turn the device off and on again using the power switch on
the bottom of the device.
• Check whether CEC is enabled. In this case, the menu cannot
be opened. This is not a defect. In some cases, the menu of the
device connected via HDMI2 opens. This is dependent on the
source device and must be supported accordingly.
• Change the input source.
• To set a "permanent" filter, you need to call up the channel list
with the O K button and then the expanded channel list with
the green button.
• Call up the expanded channel list via
and then use the
LIST
If, however, you call up the channel list during
operation via the
option, this option acts more like a search
FILTER
function. This means that the complete channel
list is displayed the next time you press the
button after closing the channel list. The previously
filtered results are not retained.
• Make sure that all settings have been correctly specified on
the device and that the Bluetooth® function is enabled.
• Check whether the device to be connected is switched on and
is in discoverable mode.
• Make sure that all settings have been correctly specified
on the device to be connected and that the Bluetooth®
function is enabled. Consult the operating instructions of the
corresponding device, if necessary.
MENU > CHANNEL
function.
FILTER
button and then use the
O K
O K