Makita EX2650LH Manuel D'emploi Et De Sécurité page 24

Outil multi-fonctions
Masquer les pouces Voir aussi pour EX2650LH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

(i) Air cleaner plate (including choke system)
(ii) Air cleaner cover
(iii) Air cleaner element
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Miscellaneous Items Used in Above Systems
(i) Hoses, Sealing gaskets, belts, connectors, and assemblies.
Makita USA, Inc will furnish with each new engine written instructions for the maintenance and use of the engine by the owner.
(e) MAINTENANCE STATEMENTS
It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2007 and
later Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended. Makita
USA, Inc will not deny a warranty claim solely because you have no record of maintenance; however, Makita USA, Inc may deny a warranty
claim if your failure to perform required maintenance resulted in the failure of warranted part. The proof, which you maintain, should be given
to each subsequent owner of the engine. You are responsible for performing the scheduled maintenance described below based on the
procedures specified in the 2007 and later Owner's Manual. The scheduled maintenance below is based on the normal engine-operating
schedule.
PROCEDURE
1) Clean engine and check bolts and nuts. Retighten if
necessary.
2) Check and refill engine oil (4 stroke engine only)
3) Change engine oil (4 stroke engine only)
4) Check clogging of cooling air passage and cylinder
fins. Remove and clean if necessary.
5) Clean air cleaner.
6) Check spark plug. Clean and adjust if necessary.
7) Check muffler exhaust outlet (or port). Clean if
necessary.
8) Check fuel filter. If clogged, replace with new one.
9) Adjust valve clearance, if applicable (4 stroke
engine only).
10) Replace fuel lines.
11) Clean and inspect the complete engine. Replace
any damaged or worn out parts.
12) Replace packings and gaskets with new ones.
: Every 8 hours (daily)
: Every 8 hours (refill daily up to upper limit)
: Initial 20 hours and every 50 hours afterward
: Every 8 hours (daily)
: Every 8 hours (daily)
: Every 8 hours (daily)
: Every 50 hours (monthly)
: Every 50 hours (monthly)
: Every 200 hours (yearly)
: Every 200 hours (yearly)
: Every 200 hours
: Every reassembling
24
INTERVAL

Publicité

Table des Matières
loading

Table des Matières