Orbit WaterMaster 57096 Manuel De L'utilisateur page 15

TRF230792 57096-27T rC.qxd
ENGLISH
use (approx. one year) the battery will weaken, and the red light will
dim. Replace the battery when the light begins to dim or if the operat-
ing distance begins to lessen.
Figure 16: Installing Transmitter Battery
To test the wireless system, hold the Transmitter near the Timer (the
Timer must have the transformer installed) and press the off/auto
resume button on the Transmitter. If powered correctly, the red light
on the face of the Timer (labeled RF Active) will flash several times,
as will the red light on the Transmitter. NOTE: If the Transmitter and
Timer do not respond accordingly, check power sources. It may also
be necessary to program the Transmitter to the Timer (see
Programming the Transmitter).
Operating the Timer Using the Wireless Features
The wireless feature allows you to perform semi-automatic timed water-
ing cycles. The normal automatic program of the Timer and the wireless
feature operates independently. However, the wireless operation has pri-
ority over any other Timer program.
(To turn on one station for a specific watering duration using the wireless
Transmitter)
Press the desired station button on the Transmitter (number 1, 2, 3,
etc.). The Transmitter will beep once, and the red light will turn on
[See Figure 17].
Press the desired watering duration on button (choose 2, 10, 30, or 60
10
3/13/03 3:46 PM Page 14
minute durations). The Transmitter will beep three times to confirm
the command. The Timer's red light will flash several times to
acknowledge receipt of the wireless signal [See Figure 17]. During
wireless watering, the Timer display will show the active station
being watered (an "A" above the station number), show remote, and
count down the number of minutes remaining for that station.
Note that the on button must be pressed within 10 seconds of the
desired station button (while the red indicator light is still lit) or you
will need to repeat the steps.
NOTE: The wireless watering has priority over any other Timer func-
tion (including automatic, semi-automatic, or manual). If the wireless
feature interrupts a functioning automatic program, the wireless
watering will occur, and afterwards the Timer will revert back to the
automatic program. However, any time occurring during the wireless
watering will be lost. The wireless feature will also override the rain
delay, or Timer off modes.
To stop wireless watering , simply press the off/auto resume button
on the Transmitter.
(To turn on all stations for a specific watering duration using the wireless
Transmitter)
Press the all button on the Transmitter. The Transmitter will beep
once, and the red light will turn on [See Figure 17].
Press the desired watering duration on button (choose 2, 10, 30, or 60
minute durations). The Transmitter will beep three times to confirm
the command. The Timer's red light will flash several times to
acknowledge receipt of the wireless signal [See Figure 17]. During
wireless watering, the Timer display will show the active station
being watered (an "A" above the station number), show remote, and
count down the number of minutes remaining for each station. Note
that each station will be activated, regardless of the programming in
the Timer.
To stop wireless watering, simply press the off button on the
Transmitter.
(N