Orbit WaterMaster 57096 Manuel De L'utilisateur page 11

TRF230792 57096-27T rC.qxd
ENGLISH
Turn the rotary dial to Watering Interval. The cursor will blink to the
left of the word Interval [See Figure 8].
Figure 8: LCD Display with Watering Interval
Press and hold the + or - keys to select the number of days between
watering. Example: If you want to water once every 10 days, set the
interval at 10.
To activate the watering interval, press enter.
Note: If an interval of "3" is entered today, the Timer will water for the
first time today, and then again every "3" days.
To select odd or even day watering, press next. The cursor will move
to either the odd or even setting, then press enter.
To erase a schedule, press clear. To enter a new schedule, press
next
.
6
3/13/03 3:46 PM Page 10
Reviewing and Changing Your Program
The Orbit Timer lets you easily review a complete watering plan.
For example, to review Program-A watering start times, simply turn the
rotary dial to the Start Times position in Program-A and check the times
that have been entered. Using the next key, you can advance through the
schedule without fear of disturbing any programming.
If you want to change the start times, watering days, or interval, simply
follow the directions for that program.
After reviewing or changing a watering schedule, remember to turn the
rotary dial back to auto if you want the Timer to automatically follow your
program.
Ready for Automatic Operation
After programming is complete, turn the rotary dial to auto
[See Figure 9].
The Timer is now fully programmed and ready to use in the automatic
mode. In automatic mode, each program will operate sequentially, start-
ing with Program-A.
Figure 9: Ready for Automatic Operation.
S
S
O
T
d
U
A
A
N
th