Atlantic SOKIO Notice D'utilisation page 37

Problem encoun-
tered
Traces of dirt appear
on the wall around
the appliance .
The Expert mode
menu is not
accessible .
The appliance
does not follow
the internal
programming
instructions .
The appliance does
not follow the ex-
ternal programming
instructions .
The appliance does
not respond to the
instructions from the
pilot wire .
Checks to make
In a polluted environment, dirt can appear on the appliance's air out-
lets or on the wall . This phenomenon is associated with the poor
quality of the ambient air (smoke from cigarettes, candles, incense, fire-
places, etc.) . In this case, we recommend checking that the room is
properly ventilated (ventilation, air inlet, etc .) .
Have your entered a PIN code? You must enter your PIN code to ac-
cess the Expert mode menu (refer to the Expert mode menu chapter) .
If you forgot your PIN code, enter code 081 .
Check that the date and time are set .
Check that the appliance is in PROG mode and that internal
programming is selected .
Ensure that the programming unit is being used correctly (refer to the
unit's operating instructions) .
Check that the appliance is in PROG mode and that internal pro-
gramming is selected . .
Perform the following checks to check for the correct transmission
of the programming instructions:
Instructions
received
0 Volt
230 V
3 s/5 min
230 V
7 s/5 min
230 V
– 115 V negative
+ 115 V positive
Within the context of programming using the pilot wire or a carrier
current, the frost protection or load shedding instructions take
priority .
The delay for switching from the Comfort mode to the Eco mode
is approximately 12 seconds .
The delay for switching from the Comfort -1/-2 mode to the Com-
fort mode is approximately 5 minutes .
Oscilloscope Ref/
Mode obtained
Neutral
COMFORT
COMFORT –
1° C
COMFORT –
2° C
ECO
FROST
PROTECTION
STOP
HEATING
37