Assembly; Assembling/Installing Equipment - Husqvarna CS 2512 Manuel D'utilisation

Assembling/Installing equipment

WARNING! Disconnect the hydraulic hoses.
!
WARNING! Always position the saw so that
!
you can stand without the risk of being hit
by a broken wire. Ensure that no
unauthorised persons can access the
working area while cutting. Being hit by a
broken wire can result in death or serious
personal injury.
Cutting needs to be planned carefully before assembling the
saw so that it can be performed as easily as possible.
Husqvarna CS 2512 can be assembled to make either
horizontal or vertical cuts. The saw is assembled standing
when you wish to make vertical cuts.
The saw is assembled horizontally when the cut is to be made
at floor height and when the cut is made in the floor.
It may be necessary to drill holes to thread the wire through
the material to be cut.

ASSEMBLY

Position the saw in an appropriate position in front of the
planned cut. When the saw is in position, secure it by
screwing down the anchor bolt.
When the saw is anchored to the floor, screw down the
adjuster feet so that the saw stands firmly.
Remember that the machine's centre of gravity (the grey
circle) is positioned between the first and second pairs of
adjuster feet (the adjuster feet pairs are marked 1-3) with a
horizontal cut (A). When cutting under the machine, it is
important that the saw is anchored well with the anchor bolt
(b) as the adjuster feet pairs 2 and 3 must be used. (Adjuster
feet pair 1 may rest on the sawn off section.) If the saw is not
anchored well it will overturn when the material supporting
adjuster feet pair 1 has been cut through.
If necessary, fit pulley wheels to assist the cutting process.
Using the pulley wheels allows the number of sharp corners
that the wire must be pulled around can be reduced, which
results in less wear to the wire at the same time as cutting is
made easier. Using the pulley wheels also lets the wire be
guided in different directions without the need of moving the
saw unit.
Also, use the pulley wheels to capture the wire when finishing
the cut.
– 9
English